VegasTeardrop.com
 TEARDROP                   
    TRAILER
CONSTRUCTION
    Page-11
Welcome back.
Here is a picture showing
the table that I made,
It hooks up to the hooks
that I showed on the
previous page.
I also made the legs so                    
that they can be adjusted
just in case I set up
somewhere were the  
ground is not level.

Here I am showing the
porch light that I installed
I put one on each side of
the trailer, there is a
switch on the bottom of
each light so that I can
turn them on without
getting into the trailer.
I also put a switch inside
I mounted switch on the
end of each speaker box
doing this I can now turn
the light on while I am in
the trailer.( If I hear a
critter or anything I just
hit the switch and I can
see what is going on
outside.)

Here you can see that I
removed the pull down
blinds that I had over my
doors earlier in my build,
I went out and found some
outdoors type material and
then I had Jan sew me up
some curtains.(A lot nicer)

You can see that I put up
some shelves above my
pillow area, Nice for cups,
and misc. I also put up
some hooks on each side
to hang up misc. Stuff.
I also put a 12volt plug in.


Here is a picture of a
padded head rest I made.






Here is a picture of my
front toolbox that I made.







Here you can see I put a tie
down cleat on each side,
These will keep my toolbox   
lid from hitting against the
front of the trailer and
scratching it.
I also use these to hold open
the toolbox lid and I use
them to hold open my side
doors.
I also put a piece of polished
stainless steel behind my
toolbox                    
<
>
TIME TO TRAILER TO PAGE 12.